Cable duct with hinged cover 9 x 5 mm.
Fixation with 1 mm thick foam adhesive.
CE marking according to LTR (low tension regulations). Complies with the European Directive on the non-use of hazardous substances (ROHS). Complies with UNE-EN-50085-1:2006 and UNE-EN-50085-2-1:2008 standards, and 73/23 CEE and 93/68 CEE directives.
Operating temperature -5 ºC, + 60 ºC.
IPXX3 impact protection (cable duct with incorporated cover). IP40 degree of protection.
Range of joining accessories available for different finishes.
Attach, conceal and/or protect electric wires.
Clean the surface on which the cable duct is to be installed, taking special care with areas where dust can linger.
If necessary, the cable duct can be cut with a hacksaw to adjust its length to the desired size.
Peel off the adhesive paper and press the cable duct on so that it is securely affixed.
Open the cover and pass the cable inside the cable duct. Once the installation is done, close the cover again.
For a more attractive and integrated visual finish, add relevant accessories at cable duct cross joints, elbow joints and intersections.
Tips and tricks
Attach joining accessories to cross joints, elbow joints and intersections for an aesthetically pleasing finish.
Cable duct can be painted in the same colour as the wall so that the installation is fully integrated with the aesthetics of the surface.
With hinged cover