Cable duct base+cover (35x16 mm).
Double inner divider designed to allow multiple cables to pass through it.
Screw fixation or Inofix 3100 plugs.
CE marking according to LTR (low tension regulations). Complies with the European Directive on the non-use of hazardous substances (ROHS). Complies with UNE-EN-50085-1:2006 and UNE-EN-50085-2-1:2008 standards, and 73/23 CEE and 93/68 CEE directives.
Operating temperature -5 ºC, + 60 ºC.
IPXX5 impact protection (cable duct with separate cover). IP40 degree of protection.
Range of joining accessories available for different finishes.
Attach, conceal and protect electric wire.
Clean the surface on which the cable duct is to be installed, taking special care with areas where dust can linger.
If necessary, the cable duct can be cut with a hacksaw to adjust its length to the desired size.
Check that the cable duct is straight and aligned with a spirit-level. Then, remove the cover, before marking the location of the holes and drilling them. Insert the plugs and screw the piece in.
Pass the cable through the cable duct. Once the fitting is complete, put the cover back on.
For a more attractive and integrated visual finish, add relevant accessories at cable duct cross joints, elbow joints and intersections.
Tips and tricks
Attach joining accessories to cross joints, elbow joints and intersections for an aesthetically pleasing finish.
Cable duct can be painted in the same colour as the wall so that the installation is fully integrated with the aesthetics of the surface.
With detachable cover